插头装配说明-K系列

1. 将电缆线依次穿过护套①、尾部螺帽②、电缆夹③、v形垫④、电缆密封圈⑤、屏蔽线压环⑥，依照次序焊接到绝缘体组件⑦的对应插针上

2. 将绝缘体卡环⑦装到绝缘体组件⑧上，注意绝缘体卡环⑦的突起和绝缘体组件⑧的缺口对应，依次把屏蔽线压环⑥、电缆密封圈⑤、v形垫④、电缆夹③推到合适的位置，保证电缆线的完整外皮插入到屏蔽线压环⑥中。

3. 将装好的绝缘体组件⑧装入到插头组件⑨中，注意绝缘体卡环⑦上的缺口与插头组件⑨中的突起对应。

4. 把尾部螺帽②拧紧到插头组件⑨上。

5. 把护套①装到尾部螺帽②上。此lemo连接器K系列FGG插头便安装成功了。

• Get the cable through sleeve① collet nut② collet③ fexible gasket④and earthing cone⑤ in order, then solder it to the corresponding contacts of insulator subassy⑦ orderly.

• Put the split insert carrier⑥ onto the insulator subassy⑦, make sure the he***e of split insert carrier⑥ mate with the slot of insulator subassy⑦, then push the earthing cone⑤fexible gasket④collet③ to the right position, assure the full sheath of cable insert the earthing cone⑤.

• Slide the assembled insulator subassy⑦ into the outer shell⑧, make sure the slot of split insert carrier⑥ mate with the he***e of outer shell⑧.

• Screw the collet nut② to the outer shell⑧ tightly.

• Put the sleeve① to the collet nut②.

以上是K系列连接器插头的装配说明，如果您有其它疑问或需要，可直接与我司销售人员联系，谢谢。